PROFI H
©V. Padagas ir ko., UAB. All rights reserved.
It is necessary to observe that the weight of the loader does not press the sweeping
machine.
Connect the hydraulic hoses so that the shaft rotates in the right direction.
Make sure the casters and the garbage bin do not interfere with the shaft.
The turned position of the sweeping machine may be selected only when working without the
garbage bin.
Before sweeping, check if the garbage bin is mounted properly and the shaft is pressed to the
base. Pressing the shaft is carried out by raising or lowering the shaft. When the rings are
worn out, the shaft must be lowered so that the sweeping segments would touch the surface
being cleaned.
If the lower rubber of the bin is worn out, the bin must be tipped to press the rubber to the
ground. Bin tipping is adjusted by shortening the tipping rod of the hydraulic cylinder (Fig.
4).
Note:
When assembling a new shaft, make sure the axle is not bent. Repair of the hydraulic system
may be carried out only in an authorised workshop. The safe condition of the sweeping machine must
be monitored during its daily operation.
Fig. 3. Bin regulation scheme.
Fig. 4. Bristle pressure adjustment