PSG-SEA
19
OPERATION
The grinder is designed for both dry and wet grinding. For dry grinding, ensure a suitable
industrial vacuum is connected and that operator is wearing suitable breathing respiratory
equipment. Starting the Grinder
1. Check the grinding plate being used are suitable for the material being ground AND
THAT THEY ARE CORRECTLY BALANCED.
2. Check that the grinding plates being used are in good order and properly attached, with
all countersunk bolts firmly in place. Check this occasionally during use, as they can work
loose during
operation.
3. Check that all Tri-knobs and the folding handle latch are tight and firm.
4. Raise the grinding plates from the floor.
5. Start the motor by pressing the black switch on the starter box.
6. Lower the grinding plate and commence grinding. Shutting down the Grinder
1. De-press the red stop button on the starter box.
CARE AND PREVENTIVE MAINTENANCE
Check folding handle latch periodically. This is adjustable. To adjust, loosen the lock nut
on the latch and then screw in the threaded paw until a satisfactory tensions has been
achieved.
Inspect the grinding discs or segments before each use.
Check all fasteners for tightness as the machine is subject to vibration.
Clean the underside of the unit regularly to prevent a build-up of material.
The wheel bearings are a sealed type, and require no regularn greasing
