PSG-SEA
17
FUNCTION AND CONTROLS
The CUB Floor Grinder is fitted with 2.2KW single-phase motor. The motor offers a direct
drive to the grinding plate with the incorporation of a flexible coupling between the motor
and the plate. The shroud system of this grinder is unique in design, automatically adjusting
to suit segment height and floor angle. This shroud system, when used in conjunction with
an appropriate industrial vacuum unit, eliminates dust loss during grinding. The shroud has
a removable section to enable the operator to grind close up to the wall. please note that
dust loss is likely when this section is removed. The grinder comes complete with a water
connection for
wet grinding should this be required. This incorporates a ball valve allowing the operator to
regulate the
water supply to obtain the best grinding results. The grinder has a foldable handle, which
enables it to be easily transported in the boot of most small vehicles. The rear wheels can
also be extended outward should the operator want more stability from the grinder. This
requires the use of a 13 mm socket or spanner. The operator can also raise or lower the
height of the handle to maximize their comfort when using the grinder.
HAZARDS AND RISKS
GENERAL GUIDELINES
NEVER allow an untrained person to operate machine without adequate instruction.
ENSURE all users read, understand and follow the operating instructions.
SERIOUS INJURY may result from improper or careless use of this machine.
USE correct manual handling techniques when moving thesurface grinder. The
machine is fitted with wheels for transport.
MECHANICAL HAZARDS
DO NOT operate the machine unless all protective guards are in place.
KEEP hands and feet clear of rotating and moving parts as they will cause injury if
contacted.
ENSURE both the machine and the operator are stable by setting up on a level
surface. Make sure the machine does not tip over, slide or fall while in operation or
unattended.
DO NOT leave the machine in operation while it is unattended.
EXERCISE CARE when operating the unit. Extended exposure to vibration or
repetitive work actions may be harmful to hands and arms.
NEVER stand on the unit while it is operating.
ONLY USE the recommended grinding discs or segments. Allow the machine to
cool before servicing or replacing parts, severe burns may be caused by coming in
contact with hot discs or segments
.
ENSURE that repairs to the motor and machine are carried out by qualified
personnel.
BEHARE
