PACLITE Equipment IMPACT430DE, Operator'S Manual

Page: 13 / 20

Reversible Compactor (2011 Version)
11
Trouble Shooting
PROBLEMS POSSIBLE CAUSES COUNTERMEASURES
The machine does not go forward
or goes forward slowly.
Oil lack in the hydraulic
pump placed on the
handle.
Place the handle in vertical
position. Add hydraulic oil until
the level indicated in the pump.
Take off air from the circuit by
lifting up and letting down the
control levers sometimes.
The machine goes only backward.
The joint of the pump is
broken or is worn out.
Replace the joint.
The machine does not go
backward or goes backward
slowly.
There is too much oil in the
hydraulic pump placed on
the control handle.
Take off oil and restore the
level indicated in the pump.
There is some air under
pressure in the pump. Open the pump plug in order to
let air go out.
The oil level in the pump is
decreasing slowly.
Loss of oil in the hydraulic
conduit.
Replace the broken part.
The cylinder joint of the
exciter is broken or worn
out so the oil goes in the
exciter.
Replace the joint and restore
the oil level in the exciter.
The engine works regularly at fully
capacity but the machine does not
vibrate.
The belt is broken.
Replace the belt.
The belt is loosening
because it is worn out.
Centrifugal clutch is
broken.
Replace the centrifugal clutch.
The engine works and the exciter
vibrates but the machine keeps
still.
Mechanical failure in the
exciter system.
Open the exciter and remove
the failure.
Address to an Assistance
Service Centre.
The engines works with difficulty,
smoke comes from the clutch and
the exciter strains.
The mechanical parts in
the exciter do not work well
(worn out bearings, loss of
oil, broken gears.)
Open the exciter and replace
the worn out parts.
Address to an Assistance
Service Centre.
The engine turns at minimum RPM
but the exciter does not stop. Centrifugal clutch is
broken.
Replace the worn out parts.
Travel speed reduced or
discontinuous.
Engine RPM are over.
Check that during work
accelerator lever is set at
maximum.
Adjust engine RPM with
appropriate tool.