PACLITE Equipment IMPACT430DE, Operator'S Manual

Page: 8 / 20

6
Pre-Start Checks
The following Pre-start-up inspection must be performed before the start of each work session or
after every four hours of use, whichever is first. Please refer to the service & maintenance section
for detailed guidance. If any fault is discovered, the Plate Compactor must not be used until the
fault is rectified.
1. Thoroughly inspect the machine for signs of damage. Make sure all guards are in placed and
secured.
2. Check hoses, filler openings, drain plugs and any other areas for signs of leakage. Fix any
leaks before operating.
3. Check the engine oil level and top up as necessary. Use proper engine oil with the proper
viscosity (SAE 10W-30 recommended).
4. Check the engine fuel level and top up as necessary. Use clean fuel. Use of contaminated
fuel may damage the fuel system.
5. Check the air filter is clean. Excessive dirt/dust accumulation within the filter element will
cause erratic engine operation. Clean the air filter element when it is contaminated. (See
Service & Maintenance Section).
6. Check for fuel and oil leaks.
Start and Stop Procedure
Before starting the engine, make sure that the Safety Switch is in ON position, Throttle
Lever is set to idle position.
1. Take the Reversible Compactor to where it is required. Use suitable lifting equipment to
position the Reversible Compactor where it is necessary. Make sure the lifting
equipment has a WLL (Working Load Limit) suitable for the Reversible Compactor
weight. Attach suitable slings or chains only to the lifting point.
2. Never leave the engine running during transporting, even if it is for a short period of
time.
3. Having carried out the checks listed in the ‘pre-start’ section, you may start the engine.
Paclite Plate Compactors are fitted with a centrifugal clutch which allows the engine to
run at idle speed without driving the Plate Compactor. The Centrifugal clutch will be
engaged as the speed of engine is increased. For correct operation, the engine speed
should be set to maximum.
Improper operation can be hazardous. Read and understand this section
before you start the machine.
CAUTION