© Sysnext. All rights reserved.
This material is not to be interpreted as a guarantee of earnings and may not be copied, reproduced, modified, published, uploaded, posted or distributed in any way,
without Packshot
Creator
’s prior consent.
Contact:
esupport.packshot-creator.com
Packshot
Creator
R3 installation
Note:
when reinstalling the pillars, make sure to set the connector and the extra wire behind the LED lamps.
Note:
to reinstall the turntable, repeat the previous steps backwards and re-calibrate the turntable.
STEP 2 : REMOVING THE BLACK PILLARS
STEP 3 : REMOVING THE TURNTABLE
Lift the
diffusion
plates up to
remove them.
A
Disconnect the connector of the
LED lights.
B
A
B
Remove the bottom hand screw.
C
Lift the black pillars up
to remove them and
repeat all previous steps
for each corner.
D
On the right of the turntable,
disconnect the cable that is
connected to the motor.
Loosen the horizontal white
hand screw that is on the side
of the block, on the right of the
turntable.
C
Loosen the two white hand
screws that are on the top of
the fixing block.
D
Loosen the black hand screws.
E
F
Slide the first part of the block
away from the turntable.
Gently lift the turntable up to
remove it.
G
Remove all the black and white
hand screws.
Remove the rest of the block
from the lightbox.
H
I
J
To remove the motor on the left
of the turntable, first
disconnect the motor cable.
Loosen the black hand screws
on each side of the motor.
K
Remove the motor from the
lightbox.
