MACHINE OPERATION
5. Adjust the flow rate of the cleaning solution with lever. Moving the solution flow control lever
downward increases the flow rate and raising the lever decreases the flow rate. There should be
enough solution to wet the floor uniformly, but not so much that the water gets past the splash
guard. Remember that the correct solution quantity depends on the type of floor, the dirt level and
the scrubbing speed
6. Release and raise the brush base lift lever to lower the brush base
7. Lower the squeegee using the squeegee lift lever
8.
SCRUBBING
This machine is equipped with brush assist propulsion. Depress the handle switch lever. The
scrub brush will begin to rotate and solution will begin to flow. During the first few yards of
operation, check that the quantity of the cleaning solution is sufficient to wet the floor and that the
squeegee dries the floor surface
WARNING!
Always lift the squeegee when moving backwards
Summary of Contents for Z210
Page 34: ...34 WIRING DIAGRAM DRAWING 10...
