SECTION 5
REMOTE OPERATION
80
5.3 PROGRAM
CONTROL
:PROGram:NAME <nn>
Command
:
selects program “nn” for executing, deleting or copying.
nn
= <0> to <99>
Query: returns the program number last selected.
:PROGram[:SELected]:DEFine <program>
Command: defines the values stored in program “nn”. Both steady-
state and transient segment parameter names and values may be
sent. Program parameters are defined in the following sections.
NOTE:
Only commas may separate the values, NO Carriage Returns
or Line Feeds may separate the values within a single Command.
Query: returns steady-state values of selected program and segment
values of most recently selected segment. "LAST" is returned with
segment data if the segment is the last segment in the program.
STEADY-STATE OUTPUT PARAMETERS
FORM,<n>,
COUPLing,<s>,
XFMRRATIO,<n.nn>,
FREQuency,<n>,
VOLTage,<n>,
see Convention #11.
VOLTage1,<n>,
VOLTage2,<n>,
VOLTage3,<n>,
CURRent:LIMit,<n>,
PHASe2,<n>,
PHASe3,<n>,
WAVEFORM,<n>,
see Convention #11.
WAVEFORM1,<n>,
WAVEFORM2,<n>,
WAVEFORM3,<n>,
EVENTS,<n>,
TRANSIENT SEGMENT PARAMETERS (OPTIONAL)
SEGment,<n>,
Only 1 segment per Program Message may be sent.
FSEG,<n>,
VSEG,<n>,
see Convention #11.
VSEG1,<n>,
VSEG2,<n>,
VSEG3,<n>,
WFSEG,<n>
see Convention #11.
WFSEG1,<n>,
WFSEG2,<n>,
WFSEG3,<n>,
TSEG,<n>,
LAST
Sent only if this is the LAST segment.
Summary of Contents for UPC-32
