Page 6 of 14
MACHINE PREPARATION
6) BRUSH INSTALLATION
a) Lift the brush base by pressing on the
foot pedal.
b) Place the brushes under the base.
Align the brush lugs with the holes in
the brush plate. Insert the brushes
into the plate and turn each brush so
the lugs are pushed toward their
retaining springs, until locked.
The
image at the lower right shows the
direction of rotation for installing the
right brush.
The left brush is rotated
in the opposite direction.
7) SOLUTION WATER
Fill the solution tank with clean water at a
temperature of no more
than 50°C
(120°F). Add the proper concentration of
liquid detergent by following the
manufacture’s instructions. Excess foam
in the recovery tank can damage the
vacuum motor. Use the minimum
amount of detergent that is necessary.
