Page 5 of 14
MACHINE PREPARATION
3) ADJUSTING SQUEEGEE HEIGHT
The height from floor to squeegee should be
adjusted based on blade wear. Rotate the
knobs counter-clockwise to lift squeegee and
clockwise to lower it.
NOTE:
Rotate the right and left adjusting
knobs until the squeegee is positioned parallel
to the floor.
4) ADJUSTING SQUEEGEE INCLINATION
During operation the rear squeegee blade is
most efficient when bent backwards roughly
3/16
ths
of an inch along its entire length.
To
increase the blade bending in the center of the
squeegee, tilt the squeegee body backward by
turning the adjuster screw counter-clockwise.
Conversely, turn the adjuster screw clockwise
to increase the bending at the outside edges
of squeegee blade.
5) INSTALLING THE SPLASH GUARD
The splash guard should be installed as
shown in the image to the right.
