4
PREVENTIVE MAINTENANCE
WARNING! Always move the Toggle Switch to the OFF
position before performing any service, maintenance, pad
changing or inspection of the machine.
After Each Use:
1. Empty the paper filter bag if full.
2. Check the paper filter bag for rips or tears.
3. Remove the pad and clean thoroughly.
4. Wipe the entire machine down with a clean cloth.
5. Store the machine inside, in a clean dry area.
Weekly:
1. Check the electrolyte level in the batteries. Add only
distilled water if the level is low.
2. Check the battery connections.
Monthly:
1. Check the batteries with a hydrometer.
2. Clean the battery terminals.
3. Check for any loose bolts or screws.
TROUBLE SHOOTING
Green Light will Not Come On:
1. Check batteries.
2. Check battery connections.
3. Check fuse behind rear panel.
4. Check wire connections to light.
5. Check light.
Motor will Not Run:
1. Check batteries.
2. Check battery connections.
3. Check wire connections to switch.
4. Check wire connections to motor.
5. Check motor.
6. Check fuse behind rear panel.
Fuse is blown
1. Check pad pressure.
2. Check motor.
3. Check wires.
MAINTENANCE
REPLACING THE FUSE
1. Move the
Toggle Switch
to the
OFF
position. The green
light should be off.
2. Lift and remove the
Upper Hood Cover
.
3. Disconnect the wires from the
Positive Terminal
of the
battery nearest the handle.
4. Remove the
Rear Panel
by unscrewing the ten (10) bolts
that connect it to the Handle.
5.
Disconnect the wires
running from the
Handle
to the
Chassis
.
6. Unscrew the
Fuse
located in the lower left hand corner of
the opening.
7. Screw a new
Fuse
to the holding blocks.
8.
Reattach the wires
that run from the
Handle
to the
Chas-
sis
.
9. Screw the
Rear Panel
back on.
10. Reconnect the wires to the
Positive Terminal
.
11. Replace the
Upper Hood Cover.
12. Turn the
Caster Knob
clockwise to raise the pad. Refer
to the Operating Instructions on page 3, Item 7 regarding
“PROPER PAD PRESSURE”
.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
