2
SAFETY
Operators must read and understand all warnings and instructions in this manual
WARNING:
INDICATES A POTENTIALLY HAZARDOUS SITUATION WHICH, IF NOT AVOIDED, COULD RESULT IN DEATH
OR SERIOUS INJURY.
WARNING:
Do not use the machine without reading the instruction sheet.
WARNING:
• This machine is only to be operated for its intended use by a trained operator.
•
Always wear personal protective equipment when operating this machine.
•
This machine is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge.
• Do not operate this machine unless it is completely assembled.
•
A qualified or authorized person must do maintenance and repairs.
•
Do not use with damaged cord or plug. If the machine is not working properly, has been dropped, damaged, left out
doors, or exposed to water, bring it to a service center.
•
To prevent electric shock, keep the machine surface dry, do not expose to rain, and store in a dry location.
• Clean with a dry cloth.
•
Machines can cause an explosion when near flammable materials and vapors. Do not use this machine near fuels, grain
dust, solvents, thinners, or other flammable materials. Do not use flammables to clean this machine.
• Always use a three-wire electrical system connected to the electrical ground.
•
For maximum protection against electrical shock, use a Ground Fault Circuit Interrupter (GFCI) protected circuit.
• Unplug the cord from the electrical outlet prior to changing pads, performing maintenance and when not in use.
•
Do not move this machine over the power cord. Always lift the power cord over the machine.
• Do not pull or carry cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners.
• Keep cord away from heated surfaces.
•
This machine has been designed for use with the pads specified by the manufacturer. The fitting of other pads may affect
its operational safety.
GROUNDING
This floor-finishing machine shall be grounded while in use to protect the operator from electric shock. The machine is
provided with a three-conductor cord and a three-contact grounding type attachment plug to fit the proper grounding type
receptacle. The green (or green and yellow) conductor in the cord is the grounding wire. Never connect this wire to other
than the grounding pin of the attachment plug. The plug must be inserted into a properly-grounded outlet in accordance with
all local codes and ordinances.
WARNING:
- Do not modify the plug provided with the machine.
Improper connection of the equipment grounding conductor can
result in a risk of electric shock. Have a qualified electrician or
service person verify whether the outlet is properly grounded.
This machine is for use on a nominal 120-volt circuit, and has a
grounded plug (see figure A). A temporary adapter that looks like
the adapter illustrated in figures B and C may be used to connect
this plug to a 2-pole receptacle as shown in figure B if a properly
grounded outlet is not available. The temporary adapter should
be used only until a properly grounded outlet (figure A) can be
installed by a qualified electrician.
EXTENSION CORDS
Use only three-wire 12/3 or larger gauge approved
extension cords that have three-prong grounding
type plugs and three-pole receptacles that accept
the appliance’s plug.
Replace or repair any damaged cords or plugs.
Use only identical replacement parts installed by
an authorized service technician.
