Appendix C - Connections
Summary
Introduction
This appendix summarizes the J1, J2 and J3 connections that
are covered in-depth in Section 2.5.
J1 - Motor
Connector
The J1 motor connector is connected in one of three ways,
determined by the lead wiring from the motor.
4-lead
For four lead wiring to the 5-pin connector wire as follows:
8-lead series
For eight lead series winding to the 5-pin connector, wire as
follows:
Rev E
5630 Installation and Hardware Reference Manual
C - 1
1
2
3
4
5
To
Drive
To
Motor
A (Black)
A (Orange)
B (Red)
B (Yellow)
Motor Case
Gnd (Green)
.27 in
.27 in
.27 in
.27 in
.27 in
(7 mm)
(7 mm)
(7 mm)
(7 mm)
(7 mm)
1
2
3
4
5
To
Drive
To
Motor
A (Black)
A (Orange)
B (Red)
B (Yellow)
Motor Case
Gnd (Green)
In addition, make the following connections at the motor:
Wire Nuts
Org/Wht
Blk/Wht
Yel/Wht
Red/Wht
.27 in
(7 mm)
.27 in
(7 mm)
.27 in
(7 mm)
.27 in
(7 mm)
.27 in
(7 mm)
