SKU 94201
For technical questions, please call 1-800-444-3353.
Page 10
If several different surfaces are to be cleaned, be careful not to damage any of the less
solid surfaces while trying to clean the harder ones. This is especially a concern when
cleaning tile and grout, bricks and mortar, or stones and mortar.
If wood is being cleaned, be careful not to damage it. Wood will usually require
resurfacing (sanding) and re-coat with a surface protectant (wood, stain, varnish) after
it has dried again. Try to avoid leaving water on a wooden surface; doing so can harm
the surface.
Maintenance
Wipe down the entire unit with a clean cloth. Do not use any solvents.
Store the unit in a clean and dry location, away from anything flammable.
If water is leaking from connections during operation, shut down the Pressure Washer
and retighten all connections.
Maintain the engine regularly according to the maintenance instructions provided
in the engine’s manual.
Refill the Pump Assembly (33) with 80 ml of SAE 75W/90 oil whenever it is serviced.
Note: The Pump Assembly (33) comes filled with oil.
the pump oil must be changed after the initial break-in period of 50 hours of
operation and every 100 hours thereafter.
PUMP MAintEnAncE cHARt*
Maintenance type
Before
Use
After
Use
Hours of operation
After initial
50 hr. Break-
in Period
Weekly
/ 10 hr.
100
hr.
150
hr.
200
hr.
Inspect tool for damage
X
Wipe off with clean, moist cloth
X
X
X
Clean Filters, Check for Pump Oil
and Water Leaks
X
X
Pump Oil Change
X
X
Seal change and regulator/
unloader/relief valve maintenance
X
Valve Change
X
*note:
This maintenance Chart is intended solely as a general guide. If performance decreases,
check systems immediately. The maintenance needs of each pump will differ depend-
ing on factors such as duty cycle, temperature, cleanness of pumped liquid, and inlet
feed conditions.
Many maintenance procedures will need to be performed by a qualified technician.
6.
7.
1.
2.
3.
4.
5.
REV 06j, 07i
