Pacific Floorcare S-24, Manual

Page: 20 / 92

RETURN TO
TABLE OF
CONTENTS
- 15 -
SOLUTION FLOW: NON-CHEMICAL INJECTION MODELS
The Solution Control Knob is located on the top left corner of the control panel. The valve electrically turns on
and off with the Scrub Head. The knob controls how much solution passes through the valve when activated.
SOLUTION DISTRIBUTION SOLUTION DISTRIBUTION
FILLING THE SOLUTION TANK
Use liquid detergent in the concentration and manner specified by the manufacturer for a 22-gallon solution
tank. Excess foam will damage the vacuum motor. In addition to properly-mixed low-foam detergent, use a
small amount of de-foaming liquid in the recovery tank. Never use pure acids.
NOTE : The front fill port strainer blocks debris from falling into the tank. Keep the solution tank free from
debris to prevent filter clogs and reduced solution flow.
1. Add water and cleaning agent via the front or rear fill port. Water temperature should not exceed 120°F
(50°C).
2. Monitor the solution level through the sight tube and the marks on the tank at the rear of the machine.
3. To drain the tank, slide the solution sight tube off of the upper fitting and lower to a drain or mop sink.