Pairing the Maxitrol Remote Handset and Receiver
1. Insert batteries four double “AA” batteries into the receiver module (Figure 99).
2. Install 3 AAA batteries into the Maxitrol remote handset (Figure 100).
3. The receiver must learn the handset code: Remove the decorative front followed by the backing plate
(Figure 102 and Figure 103). Locate the module caddy on the left-hand side of the fireplace. The reset
button is located here (Figure 101).
4. Press and hold the receiver’s reset button (Figure 101) until you hear two (2) beeps. After the second,
longer beep, release the reset button. Within the subsequent 20 seconds press the “ARROW DOWN”
button on the handset until you hear two (2) short beeps confirming the code is set. The remote handset
is now ready to use.
NOTE: This is a one time setting only, and it is not required when changing the batteries in the handset or
receiver.
Figure 99: Maxitrol receiver module.
Figure 100: G6R remote control device.
Figure 101: Maxitrol reset button location.
40
051119-48 100000300
i40 TOFINO
