300913-24
SUPER-SD1 13
Optional
Blower
The optional blower kit (kit #WODC.BLOW) is equipped
with a three prong power cord and may be installed at
any time. Follow installation instructions supplied with the
kit. Route power supply cord away from heater.
Electrical rating: 115 volts A.C.-1.02 amps.
Fan output rating: 125 CFM
Blower Operation
Proper blower speed matched with air control setting
will ensure peak performance from your stove. Operate
as follows:
- Air control set to "L" (low), operate blower speed
control on "Low".
- Air control set between "L" and "H" (low and high),
operate blower speed control at desired setting.
Automatic:
To operate the blower automatically, set the
rocker switch on the side of the fan housing to "Auto"
and set the speed control to desired setting. This will al-
low the fan to turn on as the stove heats up to operating
temperature. It will also shut the blower off after the fi re
has gone out and the unit cooled to below a useful heat
output range.
Manual:
To manually operate the blower, set the rocker
switch to "Man" and set the speed control to desired set-
ting. This will bypass the sensing device and allow full
control of the blower.
Switching from "Auto" to "Man" or selecting speed may
be done anytime.
Optional Outside Air Adaptor
The adaptor is only required if the blower kit is to be in-
stalled and outside combustion air to be ducted to rear
of pedestal.
Installation:
Remove blower kit if already installed. Place adaptor with
the 4" round hole facing up and opposite end covering
the room air knockout hole on the back of the pedestal.
Mark attachment holes on pedestal base and drill with
1/8" bit. Attach with #8 x 1/2" screws and reinstall fan.
Combustion air duct from outside can now be attached
to the 4" round collar.
Summary of Contents for SUPER 27
Page 20: ...20 SUPER SD1 300913 24...
Page 21: ...300913 24 SUPER SD1 21...
Page 22: ...22 SUPER SD1 300913 24...
