NEO 2.5 INSERT LE_221119-28
11
100003382
Baffle Removal
Chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible
should you remove baffle assembly.
WARNING:
If you Sweep/Clean the chimney with the baffle removed, be sure to plug the top of the baffle
tube in the back of the firebox before sweeping or cleaning. Failure to prevent ash or soot from falling into
the baffle tube will cause incorrect operation and will lead to premature burn out of the tube or baffle.
DO NOT OPERATE WITH BAFFLE ASSEMBLY, TUBES OR INSULATION REMOVED.
Baffle Removal
1. Remove retaining pin at the back of the firebox, just under the baffle.
2. Lift the Baffle up to disconnect from the Baffle Supply Tube.
3. Pull the Baffle towards you, then tilt it sideways to drop down and remove from firebox. You may need to
remove the opposite side brick rail to allow the Baffle to drop down. To remove the Brick Rail, remove the
brick directly under it then lift the rail up and inward to clear the locating pins
4. Inspect the gasket between baffle and supply tube. If necessary, replace with gasket (prt#80000365)
available from your Pacific Energy dealer.
5. Re-install baffle assembly in reverse order.
