2. Remove the screws securing the access cover to the
firebox bottom. Inspect airbox for debris. If debris is
present, carefully use a vacum to suck debris through
the hole in the firebox bottom.
3. Replace the cover plate and the bricks.
Glass Cleaning
If glass becomes darkened due to poor burning conditions,
it can be cleaned with fireplace/ceramic glass cleaner when
the fireplace is cold. Never scrape with an object that might
scratch the glass. The type and amount of deposit on the
glass is a good indication of flue pipe and chimney buildup.
A light brown dusty deposit that is easily wiped off usually
indicates good combustion and dry, well-seasoned wood and
therefore relatively clean pipes and chimney. On the other
hand, a black greasy deposit that is difficult to remove is a
result of green wood or poor draft. NOTE: This heavy deposit
is building up just as quickly in the chimney.
Blower Replacement
1. Remove the surround front by lifting and pulling away
from the unit. Remove the four screws securing the back
surround to the brackets and set the surround aside care
-
fully to avoid damage.
Fig. # 2
Fig. # 3
BOLTS
BOLTS
Fig. # 4
L2 (neutral)
G (ground)
L1 (hot)
Blowers
Thermo
Switch
Junction
Box
Electrical Rating : 115 V, 60 Hz, 1.1A
To wall
switch/control
2. With a 3/8” wrench, loosen the two bolts securing the
blower mounting bracket to the unit. Fig. #2
3. Disconnect the two wires leading to the blower motor.
4.
Lift the blower mounting bracket up and pull the top out
first and then lift the blower up and out to remove from the
bolts.If replacing the right side blower, then disconnect
the two wires leading to the thermo-switch at this time as
well.
5. Remove the three bolts securing the blower to the mount
-
ing bracket and replace the blower. Fig. #3
Fig. # 1
COVER
8
5055.7618_210916-32
FP25.BODYA
