13
ADL Sentry User Guide
Setting up in the Field
1.
Attach the antenna to the radio, either directly to the top of the radio or to an antenna cable.
2.
Attach the radio to your tripod using the tripod clip on the back of the radio. See the fi gure be
low for setup suggestions.
3.
Connect the radio to the source of the data you will transmit, for example, a GPS receiver, using
the data/power cable. Th
e ADL Sentry radio uses the same data connector – with the same pin
outs - found on the PDL HPB radio. Th
is makes the radios compatible with existing HPB data
cables.
4.
Join the data/power cable’s SAE connector to the 12 Volt battery’s SAE connector. Th
is will turn
the radio on. If the radio had previously been powered on and then off , turn it on again by
pressing the On/Off button in the center of the front panel.
Summary of Contents for ADL Sentry
Page 1: ...ADL Sentry User Guide...
