INSTALL ATI ON OF TH E FAUCET
1
New Faucet Preparation
Shut off the water supply. Remove the old
faucet by disconnecting the supply tubes
under sink and then unscrewing the faucet
from the counter top by removing the
mounting nuts. Clean the sink top surface
in preparation for the new faucet.
2
Install Faucet on Sink Top
Place the faucet in position on the sink.
From under the sink, place the mounting
nuts on the threaded shanks and tighten.
Install the plastic deck plate under the
faucet. (
Note
: If the sink surface is uneven
or irregular, plumber’s putty or a silicone
sealant may be used to create a watertight
seal. Plumbers putty may have an adverse
reaction with some cultured marble or
natural stone. In these cases a high-quality
silicone sealant may be used.)
3
Install Faucet Hoses
If you have a hose supply that is long
enough to reach the faucet lines, assemble
as follows: slide water supply hose into
faucet’s connections, and side nut up to a
flush position. Hose will go partially into
faucet’s connection. Carefully hand tighten
nuts, then use a wrench to hold the hoses
securely into place. Plumbers Tape may be
used to help prevent leaks.
4
F
lush Hot and Cold Water
Once installation of hoses is complete,
remove the aerator. Turn the water supply
on and allow both hot and cold water to
run for 30 to 60 seconds. While water is
running, check for leaks around and under
the sink. Once done replace aerator. Your
Pacific Bay faucet is ready to use.
MAINTENANCE AND CL EANING
Cleaning Tips: The finish on your product
is designed to retain its beautiful sheen
for years. To maintain the original look of
the finish, a little care and caution should
be used. We recommend the use of mild
soap and water to clean the product.
THE USE OF ABRASIVE CLEANERS MAY
SCRATCH THE FINISH OR CAUSE
OTHER DAMAGE.
RECOMM ENDED TOOLS AND
MATERIALS
¨
Adjustable Wrench
¨
Plumbers Tape (Thread Seal
Tape)
¨
Plumber’s Putty or Silicone
Sealant
BEFOR E YOU BEGIN
There are a variety of things to do before
installing any new plumbing system into
your home or residence. Before you begin
work make sure you:
¨
Shut off the main water supply
¨
Cover your drain to prevent
loss of parts
¨
Observed any local plumbing
codes
¨
Inspect fixture for damage -
Replace as necessary
Pacific Bay reserves the right to make any
revisions in the design of products without
notice.
