Checkout
Inspect the board for any bad solder joints, shorts or other problems and correct before use. Confirm for proper
orientation of parts.
Install the telescoping antenna using the supplied nut in the location market “ANT”. Tighten the nut gently to
secure the antenna in place.
Install a 9V battery and press the power switch. The led should light. If not, recheck solder joints and component
placement.
Usage
Use a bnc adapter or cable to attach the active antenna to a receiver. If attaching to a transceiver, use care not to
transmit into the active antenna as doing so will likely cause damage.
Turn on your receiver and tune to the band of interest. Press the power switch on the active antenna and you
should hear a significant increase in background noise and possibly signals.
Tune the receiver and you should hear signals as you would with any other antenna.
While a short antenna is a compromise, an active antenna such as this can often equal performance of a wire
antenna.
Performance of the active antenna can be improved by adding a short 3-5ft section of wire to the telescoping
antenna. Just use a clip lead to attach the wire to the end of the telescoping antenna to extend its length.
Always turn off the power switch when not in use to avoid draining the battery.
Packaging
Packaging is left up to the builder. The kit can be used as is, built into another assembly or installed in a
case.
Thank you for purchasing our Active Antenna kit!
Support: [email protected]
ActiveAntenna20191111
8
Copyright Pacific Antenna 2019
