After the first support pin is soldered, recheck that the connector is seated on the board. If not, reheat the
connector support pin while pressing down on the board to fully seat it.
Once the connector is seated and both support pins are soldered, go ahead and solder the two signal connection
pins (smaller) on the BNC.
Battery Holder
Locate and install the battery holder in the location J1 using the included flathead screws and nuts.
Once secured, with the screws, solder the two pins that provide power to the board.
Rubber Feet
If the kit is not to be mounted in an enclosure, go ahead and install the 4 rubber feet to the bottom corners of the
board where the holes are located.
This prevents shorts from metal surfaces and protects tabletops, etc from damage from the circuit board.
Congratulations, you have completed assembly or your Active Antenna kit!
ActiveAntenna20191111
7
Copyright Pacific Antenna 2019