18
Lens Vision Attachment
Installation
Use the following instructions and accompanying illustrations as a guide to install the Lens Vision Attachment,
part number 6018-0104.
1. Remove the Clamp Screw from the end of the Support Shaft Assembly.
2. Hold the Support Shaft Assembly as shown with the flat portion of the rod on the right side. Insert the
rod end of the Support Shaft Assembly up through the hole in the Pivot.
3. Tighten the Shaft Locking Knob to secure the Support Shaft Assembly in position.
4. Install the Clamp Screw (removed in step 3) onto the end of the Shaft Support Assembly.
5. Position the Lens Bracket on the Support Shaft Assembly as shown with the holes in the bracket
aligned with the mounting holes in the Support Shaft Assembly.
6. Secure the Lens Bracket to the Support Shaft Assembly as shown using the 2 Mounting Screws.
7. Place the Lens in position on the Lens Bracket in the following manner.
a) Position the Lens as shown with the Lens directly beneath the Lens Bracket.
NOTE
To ease installation of the Lens, you may wish to loosen the Shaft Locking
Knob, raise the Support Shaft Assembly (with attached Lens Bracket) and
secure in position by tightening the Shaft Locking Knob.
b) Place one of the rotation knobs (on ends of the Lens) into one of the Rotation Cylinders on the
Lens Bracket.
c) Gently pull the second Rotation Cylinder out slightly and place the second Lens rotation knob in
the free cylinder.
d) Release the Lens Bracket. The bracket will now spring back together to hold the Lens in position.
Vision Systems
