MANUAL MODE COMPONENT INSTALLATION
1. Install the proper Nozzle and Vacuum Cup (if not using Single Jet nozzle) onto the handpiece.
Figure 30.
2. Set the unit POWER Switch (on rear panel of power source) to the ON
position.
Figure 31.
3. Press and release
MODE/ESC
Key as necessary until the
MANUAL
Mode
Light is illuminated.
4. Adjust the Set Temp as desired using the Temperature Scroll Up and Down
keys. Press and hold the key; observe the Digital Readout as the Set
Temperature increases (or decreases) in 1° and then 10° increments as the
key is held.
5. Adjust the Blower Speed (1-9) as desired using the Blower Speed Scroll Up
and Down keys.
Figure 32.
36
Operation
Summary of Contents for TF 200
Page 2: ...MANUAL NO 5050 0420 REV C i ...
Page 26: ...21 Quick Start ...
