31
Repair
Repair Procedure
The "Repair" section of this manual provides the technician with the information
necessary to determine the source of a malfunction and take the necessary steps to
correct it. In order to perform the most expedient repair, the technician must follow
the process listed below step by step, in order. Failure to do so will make the
diagnosis and repair much more difficult.
1.
Periodic Maintenance
- Required on any PACE handpieces used. Refer to
the handpiece portion of this manual for specific instructions. No periodic
or special maintenance is required on the power source.
2.
LED Display Message Codes
- Many operation errors or system
malfunctions are detected by the system and displayed on the LED
Display. Check the LED Display for error messages and refer to
the LED Display Message Codes table (Table 2).
3.
Corrective Maintenance
- A guide for resolving minor malfunctions.
Locate the "Symptom" in the Corrective Maintenance Table which
best describes the malfunction. Check each point described under
"Solution" in order of listing.
4.
Disassembly/Assembly
- Contains simple instructions which enable
the technician to open/close the unit for servicing.
5.
Repair Drawings
- Exploded power source, wiring diagram and
schematic are included as aides in troubleshooting and repair.
6.
PACE Service Department
- If the cause for malfunction has not
been determined at this point, call the PACE Service Department
at tel.1-888- 535-PACE (toll free) or FAX 301-483-7030.
Summary of Contents for ST 115
Page 1: ...Operation MaintenanceManual ST115Systems ...
Page 42: ...38 Repair Wiring Diagram ...
Page 43: ...39 Repair Schematic ...
Page 44: ...40 Repair ...
