WARNING: To avoid potential property damage or personal injury, Read
Important Safety Warnings and ALL instructions before attempting to install or
service product.
CAUTION:
Care must always be taken to install the control cover without
bending the connector pins identified in
FIGURE 1
.
4.
Slide (3) ring terminals of new harness
over threaded posts of PCB and route
wires as shown
Align each colored wire to specific
threaded post identified only.
5.
Secure wire terminals with (3) nuts.
Torque to 12 to 14 in-lbs
Use the torque value specified.
Blue Wire
“A”
Orange
Wire “B”
Yellow
Wire “C”
6. Plug 2-Pin connector of new
harness into PCB
7. Orient ring terminals and
route wiring harness out of
cover as shown
8. Replace (2) wiring grommets,
cover, and (4) cover screws
Figure 2
Page
34 of 40
Number
PM820010
HVAC: SmartAir eHVAC System
