Pacbrake is a registered trademark of Pacbrake Co.
4
HP10121 AMP AIR SUSPENSION KIT
L5934
L5934.REV10_16.07.2018
4
INSTALLATION ON THE VEHICLE
Raise the vehicle enough for a comfortable working height with a floor jack
and support the axle with jack stands.
Remove the jounce bumpers on both sides.
5
Remove both lower shock absorber fasteners. Retain nuts and bolts for reuse.
Remove the 2 nuts holding the sway bar up to the axle tube bracket on both
sides. Allow the sway bar to swing down towards the ground. Discard the factory
sway bar bolts and retain the nuts for re-use.
6
The passenger side shock absorber mounting bracket has an emergency brake
cable support bracket that needs to be removed.
7
The top of the rear end housing has a bolt supporting the cable to the top of the
rear end housing. Remove the bolt and bracket and re-install the bolt.
8
On the passenger side only, compress the shock absorber to allow the e-brake
cable to be moved to the forward side of the shock absorber.
STEP 4
STEP 6
STEP 5
STEP 8
STEP 7
