
PAC
®
| Ph. 866-931-8021 | [email protected]
©2016 Pacific Accessory Corporation
www.pac-audio.com
Rev. 082616
Page 3
Reverse Camera Input and Navigation Unlock
Interface for Chrysler / Dodge / Jeep / RAM Vehicles
BCI-CH41
(R.2)
Rear Media Mode
If you have DIP switch 2 in the ON position, it will activate Rear Media mode on the factory screen (8.4” screens only).
PLEASE NOTE:
In order to access Rear Media mode for the first time, you will need to turn the key ON, then OFF and let the vehicle go to
sleep (about 1 minute), then turn the key ON again, then OFF again and let the vehicle go to sleep a second time (about 1 minute).
To access Rear Media mode follow these steps:
Press the “Media” icon in the bottom left corner of the screen (Fig. F).
1.
Press the down arrow on the middle left of the screen (Fig. G).
2.
Press the “AV1” icon on the middle left of the screen (Fig. H).
3.
Press the “Full” icon on the right middle of the screen to view the video (Fig I).
Fig. G
Fig. F
Fig. H
Fig. I
Operation (cont.)
Nav Unlock
If you have DIP switch 3 turned ON, you can activate the navigation unlock which will enable any features
that are normally locked out while the vehicle is in motion.
To activate the navigation unlock, follow these steps:
1.
Place the MFD in the mode that displays radio text.
2.
Press and hold the center button on the back right side of the steering wheel for at least 4 seconds,
then release (Fig. J).
3.
The MFD in the cluster will display “Confirm Safe Passenger Use”.
4.
Press the same button again within 5 seconds to acknowledge “safe use”,
agreeing that use will
be performed only by the passenger whenever the vehicle is in motion
, and activate
the navigation unlock.
5. The MFD will display “Acknowledged”.
6.
To de-activate the navigation unlock simply press and hold the same button for at least 4 seconds
and then release.
7.
The MFD will display “NU Deactivated”.
Preset EQ
• This feature is only available in vehicles equipped with a factory amplifier.
•
If you are using preset 1, 2 or 3 and not “P”, the EQ shown on the radio may not
be what you are hearing. The interface cannot force EQ settings that the user has
stored onto the factory radio.
This feature can be enabled in the Feature Settings menu outlined on Page 2.
Presets can be viewed on the MFD when it is set to audio mode and the Mute button is pressed.
To access / store presets follow the procedure below.
1.
Presets can be recalled by simply pressing the Mute button located in the center of the volume knob
(Fig K). Repeatedly pressing this button will scroll through the presets and the pass through. The
pass through is the one labeled “P” and will set the EQ to whatever is displayed on the radio screen.
2.
To store a preset, press the Mute button until you get to the desired location. Next, go to the equalizer
screen by pressing Audio > Equalizer and set it to the desired sound. Now press and hold the Mute
button (Fig I) until the MFD displays “Storing EQ”.
Fig. J
Fig. K