6
Safety Precautions
Read these instructions carefully before you install, operate, or transport the PAC Storage PS
3000 Gen 1 Series Unified Storage System and expansion enclosures.
Energy Hazards Precaution
This equipment is intended to be used in Restrict Access Location, like computer room.
The access can only be gained by SERVICE PERSONS or by USERS who have been
instructed about the metal chassis of the equipment is have energy hazards that service
persons have to pay special attention or take special protection before touching it. Further,
the access is through the use of key or security identity system. Only authorized by well
trained professional person can access the restrict access location.
Installation and Operation
Install the rack cabinet and the associated equipment at a site where the ambient
temperature (special room cooling equipment may be required) stays lower than:
a.
35
C
~ if your system has a BBU
b. 40
C
~ if your system does not have a BBU
Install the power source socket outlet near the enclosure where it is easily
accessible and ground the rack cabinet.
-
Secure airflow clearance inside and around the rack cabinet.
-
Secure an 18 to 20cm clearance on the rear side.
-
Do not cover the enclosure openings.
-
Route the cables inside the rack cabinet.
-
Do not leave drive bays empty as it will affect airflow efficiency.
Secure each enclosure module using its retaining screws.
Place power cords and other cables away from foot traffic. Do not place items on top
of power cords and make sure they do not rest against data cables.
Install all modules to the enclosure before powering-on systems.
Ensure that the correct power range is being used before powering-on.
DO NOT remove covers or replaceable modules if they are not faulty.
If the system is not going to be used for a long period of time, disconnect it from the
power mains to avoid transient over-voltage.
For power source redundancy, please make sure that the two PSUs are plugged into
two different power sources (i.e. Different circuit breakers).
Service and Maintenance
Keep the faulty module in place until you have a replacement unit; an empty
module greatly affects the airflow efficiency within the enclosure.
During service operation, place the enclosure on soft and clean surface to prevent
exterior damage. Do not place tools or other items on top.
