29
3.5 inch
2.5 inch
With the drive tray bezel opened, align and insert the tray into the enclosure. Once fully
inserted, close the tray till it’s snapped.
Installing Host Boards
NOTE
Be aware that upgrading the controller / host board down time may occur.
If you are using a SAS expansion host board, it can be ONLY inserted into host board
2 (which is on the right), and you cannot insert two (2) SAS expansion host boards.
The firmware will automatically restore the system to factory settings when you add or
replace a host board.
Shutdown and remove the controller from the enclosure.
For users installing a new host board, you will need to remove the screws holding the
dummy covers in place.
If you are replacing an existing host board, please loosen the thumb screw that is
securing the host board onto the controller and gently lift the host board.
