PA SDI-Drives Midi™ / Maxi™
Edition
07.44
Power Automation
2.3.3 Additional
Safety
Notes
•
Only qualified personnel are permitted to install and set up the “safe restart lock”
function
•
All control components (switches, relays, PLC, etc.) and the control cabinet mus
comply wit
in
–
Door – switches, etc. with protection class IP54 as minim
–
t
h the requirements of the EN 954-1, EN 954-2 and ISO 13849. This
cludes:
um
Control cabinet with protection class IP54 as minimum
•
dback contact)
outside the control cabinet.
•
art lock” (e.g. force to
the load by hanging load) additional measures have to be provided (e.g. double-disc
ailure to observe this precaution can result in severe injury and equipment damage.
e m
hed off by e.g. a mains contactor in
cleaning, maintenance and repair operations
w any one of these instructions will result in death, ser
quipment damage.
Back to Content
•
Use insulated wire end sleeves
•
Control cable length of the inputs ENABLE, LOCK, EN-BRAKE and output
“SAFE LOCK” is limited to 25 m max.
All safety-relevant cables (e. g. control cable for the safety relay, fee
has to be installed e. g. in a cable duct, if pass
Make sure, that short circuits between single cables are excluded!
For further measures see EN 954-2, table D4
When an external force is likely to act with the function ”safe rest
spring set brake, instead of permanent magnetic-excited brake)
F
Th
ains power supply of the drive has to be switc
case of:
•
•
long down time periods
Failure to follo
ious injury or
e
s
SDI Interface Manual
8
