6
MAN 9037782 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70 21 26 26
DK-6600 Vejen
e-mail: [email protected]
Troubleshooting:
Fault
Cause
Repair
Motor buzzes and does not
reach rpm.
Missing phase.
Check the power connection and
fuses.
Connect the power
supply and switch the
saw on and off again.
(Switch goes off).
Zero wire
missing.
This fault must be repaired by an
electrician.
Note:
If the start switch has been blocked so you can work without a missing zero wire, the
switch will quickly be destroyed.
In such cases, the damage is not covered by the warranty!
Component overview
Start / Stop switch
Emergency Stop
Power connector with
phase transformer
Motor
Transport bar
Blade guard
Safety plate
Tilting table
Support bracket
Transport lock
Return spring tilting table
Wheel