4
MAN 9062812 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: 70212626
DK-6600 Vejen
e-mail: [email protected]
Assembly Instructions
•
Attach the beams to the welded end
frame posts starting at the bottom
level by using both end frames to
establish the left and the right sides of
the units.
•
After a beam has been placed in both
end frame post slots, tap the beam
down at both ends with a rubber
mallet to help drive the beam bracket
tabs into the slot to secure the beam.
Continue assembling each level from
bottom to top level (front and back).
•
If the beam bracket tabs become bent due to mishandling, it may be necessary to
adjust the tabs back to their proper form.
•
The completed unit should have four levels envenly spaced for maximum stability.
•
Although the beams are adjustable in height, it is recomended to evenly space them
so that the stability of the unit is not compromised.
•
Install 1 cross bar B in each level by inserting and tightening the bolts, nuts and
washers into the holes located alon the inside bottom center edge of the beams.
•
Install 3 cross bar A in each level by inserting the tab located on both ends of the cross
bar A into the slot holes located along the inside top edge of the beams.
•
Insert the wire deck on each level.
We reserve the right to change the technical parameters and specifications of this product without prior notice.
