Page 9
Tools and Parts Required
Task
2x Screws
Mounting controller to wall
2x Anchors (optional)
Mounting controller to wall
Drill
Mounting controller to wall
Screwdriver
Mounting controller to wall
RJ12 Crimp Tool (optional)
Modifying cable length
1. Determine the optimal location for the controller. Heed warnings in Section 5.
Caution! The P.L. Light iQ
™
controller should only be mounted on a sturdy, solid surface.
2. Holding the controller in desired location, mark the position of the holes on the
mounting surface, using the mounting tabs (on either side of the controller).
3. Set controller aside and drill holes in marked locations from step 2. Insert anchors
into holes if required.
4. Position controller against mounting surface—mounting tabs should be aligned with
drilled holes. Insert one screw into each hole and tighten with a screwdriver until con-
troller is securely attached to the mounting surface.
Note: Ensure not to over tighten to avoid breaking the mounting tabs.
9.Installation
