P.I.T. PSB13-C2, User Manual, Page: 7 / 22

Impact Drill
06
The drill chuck must be tightened
using a tightening torque of approx. 50–55
Nm.
For keyed chucks
Screw the securing screw anticlockwise into
the open keyed chuck.
Dust/Chip Extraction
Dust from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one’s health. Touch-
ing or breathing-in the dust can cause allergic
reactions and/or lead to respiratory infections
of the user or bystanders.
Certain dust, such as oak or beech dust,
is considered carcinogenic, especially in
connection with wood-treatment ad- ditives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
–Provide for good ventilation of the working
place.
–It is recommended to wear a P2 fi lter-class
respirator.
Observe the relevant regulations in your
country for the ma- terials to be worked.
►
Avoid dust accumulation at the work-
place. Dust can easily ignite .
Operation
Starting Operation
►Pay attention to the mains voltage. The
voltage of the power source must match
the voltage specifi ed on the rating plate of
the power tool. Power tools marked with
230 V can also be operated with 220 V.
Setting the rotational direction
The rotational direction switch is used to
change the rotational direction of the power
tool. However, this is not possible while the
on/off switch is being pressed.
Right rotation: To drill and to drive in screws,
press the rotational direction switch through to
the right stop.
Left rotation: To loosen and unscrew screws
and nuts, press the rotational direction switch
through to the left stop.
Setting the Operating Mode
Drilling and screwdriving
Set the selector switch to the “drilling”
symbol.
Impact drilling
Set the selector switch to the “impactdrill-
ing” symbol.
The selector switch clicks into place and can
also be actuated when the motor is running.
Switching on/off
To start the power tool, press and hold the
on/off switch.
Press the lock-on button to lock the on/off
switch in this position.
To
switch off the power tool, release the on/
off switch
,
or, if the switch is locked with the
lock-on button, briefl y press the on/off switch
and then release it.
Adjusting the Speed/Impact Rate
You can adjust the speed of the power tool
when it is on by pressing in the on/off switch
to varying extents.
A light pressure on the on/off switch results in
a low rotational speed. Increased pressure on
the switch causes an in- crease in speed.
Preselecting the Speed/Impact Rate
You can preselect the required speed/impact
rate using the speed preselection thumbwheel
, even during operation.
The required speed/impact rate is dependent
on the material and the work conditions and
can be determined by practical trials.
Practical advice
►Pull the plug out of the socket before
carrying out any work on the power tool.
When drilling into metal, only use sharpened
HSS drills (HSS= high-speed steel) which are
in perfect condition. Use a drill stand for jobs
that require particular precision.
Maintenance and Cleaning
Maintenance and Cleaning
►Pull the plug out of the socket before
carrying out any work on the power tool.
►To ensure safe and efficient operation,
always keep the power tool and the venti-
lation slots clean.
►For safe and proper working, always keep
the machine and ventilation slots clean.
When the battery is no longer operative,
please refer to an authorised after-sales ser-
vice agent for P.I.T. power tools.
Dispose of waste
Damaged power tools, batteries, acces-
sories and waste packaging materials must
be recycled and reused in an environmentally
friendly manner.
Do not throw power tools and accumulators /
batteries into general household waste!
Product serial number interpreta-
tion