OZtrail DTMENSPU-B, Owner'S Manual

Page: 3 / 12

3
Assembly Instructions
Do not force the sprung steel frame, follow instruc
ti
ons carefully
Step 1 Choosing the Site
Select a sheltered camp site protected from the wind that will not allow water to pond
under the tent
fl oor. Clear a level area of all stones, twigs, etc.
Step 2 Standing the tent up
Remove pegs from carry bag. Remove the tent from the carry bag and carefully release
elas
ti
c strap, gently allow the tent to unfold and open fully. All four walls should be apart
and all inside corners open to 90 degrees.
Step 3 Peg down the tent
Posi
ti
on the tent facing the desired direc
ti
on. Peg the four corners of the tent to the
ground by inser
ti
ng the pegs through the loops around the base of the tent at an angle of
45 degrees. Firm but not
ti
ght.
Step 4 Install guy ropes
Use all the guy ropes a
tt
ached to the tent. Make a loop (about 30 – 50cm long) with the
slider on the end of the rope and peg out as far as possible from the tent. Ensure all peg
down points are u
ti
lised and all guy ropes are a
tt
ached fi rmly and remain fi rm.