Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority for
recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your local
council authority for recycling advice.
MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
1. When not in use, the tool should be stored in a dry, frost free
location, keep out of children’s reach.
2. Keep ventilation slots of the tool clean at all times and prevent
anything from entering.
3. If the housing of the tool requires cleaning, do not use solvents.
Use of a cloth only is recommended.
4. Blow out the ventilation slots with compressed air periodically.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by repair of the tool by an unauthorised person or by
mishandling.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
LED lights do not illuminate on charger
Check the charging adaptor is securely plugged into the wall
outlet.
Check the battery is firmly connected to the charging cradle.
Check that the charging jack is securely connected to the
charging cradle.
The battery has a short run time
Ensure the battery is properly charged. It will take 4-5 charging
cycles before the battery reaches optimum charge and run time.
Multi function tool has cut out during use
It is likely that the battery’s thermal voltage protection has been
activated. This can happen when the tool has been used for
extended periods.
Place the battery on the charging cradle for 2-3 hours. It will need
this time to cool down and for the protection circuits to be reset.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing
vents. This is normal and does not indicate a problem.
Warning
Wear eye protection
Read instruction manual
Ah
n
0
Amp hour
Regulator compliance
mark (RCM)
r
No load speed
V
Volts
Hz
Hertz
ac/~
Alternating current
Direct current
dc/
/min
Diameter
Revolutions or
reciprocation per minute
