Removing The Nozzle
The nozzle ejector function allows you to swap nozzles without having to
wait for it to cool.
1. To eject the nozzle, twist
the chuck of the heat gun
clockwise against the tool.
The nozzle will pop right off.
WARNING!
ONLY HOLD THE PLASTIC PORTION OF
THE HEAT GUN. TOUCHING THE METAL NOSE CAN
CAUSE BURNS.
WARNING!
BEWARE OF THE EJECTED NOZZLE
FALLING. CONTACT WITH SKIN CAN CAUSE BURNS
IF THE NOZZLE IS STILL SUFFICIENTLY HOT.
Fitting The Battery
1. Slide the battery into the
tool base until it clicks into
place.
2. To remove the battery, hold
down the battery release
button and then slide the
battery out.
Switching The Tool On/Off
1. Push and hold the lock-off button
to either side of the tool.
2. Pull the on/off trigger to start the
tool. You may now release the
lock-off button.
3. Release the on/off trigger to stop the heat gun
Note:
The motor will continue running for a few seconds after you
release the trigger. This draws cool air over the heating elements, cooling it
faster and prolonging the life of the tool.
WARNING!
THIS TOOL IS DESIGNED FOR INDOOR
USE ONLY. USING THIS TOOL FOR PROLONGED
PERIODS MAY CAUSE IT TO OVERHEAT AND
MALFUNCTION. ALLOW FREQUENT BREAKS FOR
THE TOOL TO COOL DOWN DURING USE.
LED Worklight
The inbuilt LED light automatically
switch on when the tool is started
up.
3. CONTROLS
OPERATION
a.
b.