Paint Removal / Softening Adhesives
1. Position the nozzle 2.5cm from
the surface.
2. Move the heat gun side to side until the paint
starts to blister or the wall paper begins to
peel.
WARNING!
DO NOT KEEP THE HEAT GUN POINTED
AT ONE LOCATION FOR TOO LONG AS THIS MAY
CAUSE THE PAINT TO OVERHEAT AND BURN,
MAKING IT HARDER TO REMOVE.
3. Use a scraper to remove the
softened paint.
Defrosting Water Pipes
The reflector nozzle may be used for more even heating if the pipes are
narrow enough to fit .
1. Heat the frozen area
inwards from the outer
edges towards the centre.
Shrink Fitting Plastics
1. Attach the reflector nozzle.
2. Slide the heat shrink tube into
the desired location and place
the spoon of the reflector nozzle
around the wire section.
3. Switch on the heat gun and allow
the plastic to heat and shrink into
place.
Note:
Rotate the wire section
if possible or move it side to
side within the nozzle to avoid
overheating in one spot.
Soldering
1. Attach the concentrator nozzle.
2. Hold the heat gun 2cm from the soldering site
and allow it to heat up.
3. Apply solder as usual.
PXHGS-550
4. APPLICATIONS
2cm
2.5cm
2.5cm
WARNING!
ENSURE THAT THE METAL NOSE AND
NOZZLE DO NOT COME INTO CONTACT WITH
MATERIALS DURING OR AFTER OPERATION.
