DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
min¯
Revolutions or
reciprocation per minute
Double insulated
Regulator compliance mark
n
o
No load speed
Warning
Wear eye protection
Wear hearing protection
Wear safety gloves
Danger! Keep hands away
from blades
Read instruction manual
TROUBLESHOOTING
Problem
Possible Cause
Solution
Sparking visible through the housing
vents
A small amount of sparking is normal
Excessive sparking could be due to worn carbon
brushes
Does not indicate a problem
Replace carbon brushes
Saw will not start
No power supply
Ensure saw is connected to a mains outlet
Saw starts but runs and performs
poorly
Workpiece too thick
Incorrect blade size
Motor difficulties
Ensure workpiece is within the saws cutting capacity
Ensure correct blade size is fitted
Contact Ozito customer service
Cutting head will not lower
Safety guard preventing lowering
The safety guard stop needs to be pulled back to allow the guard to swing up
Mitre table will not rotate
The mitre lock handle not loosened
Mitre adjustment lever needs to be pressed
Loosen the mitre lock handle before rotating
Press the mitre adjustment lever down
Bevel angle will not adjust
The bevel angle lever needs to be released first
Loosen the bevel angle lever then tilt the cutting head
Cutting head will not slide forwards
or backwards
The cutting head slide is locked
Loosen the sliding lock before sliding the cutting head
