1 Insert the Splitter by
securing in pace with
the 2 fixing screws.
Ensure the table saw it set up
on a level work bench or sturdy
table
The base of the saw has
bench mounting holes that
can be used to mount it to a
workbench if desired.
A vacuum can be fitted to the
dust extraction port at the
back of the table saw to help
remove dust while operating.
2 Slide the rip fence onto
the table and secure in
the desired position by
tightening both locking
knobs.
Note:
The fence can be used
with either the low or high side
facing the blade, depending on
the thickness of the material.
1 To fit the rip fence, the 2
locking knobs must first be
fitted.
Place the locking plate
behind the fence tab and
then insert the locking
knob with washer through
the fence tab and into the
locking plate.
The mitre guide can be slid
into the end of the rip fence to
allow for simple 45
0
cuts.
4 Mount the blade guard
onto the top of the
splitter.
2 Fit the splitter loosely
using the 2 screws.
Adjust so that is 3-5mm
away from the blade
then tighten the screws
to secure in position.
Note:
The distance between the splitter and saw blade should be
checked each time the blade is changed.
5 Insert the mounting
bolt through the blade
guard and splitter and
then tighten the knob to
secure.
3 Fit the table insert and
secure using the 2
screws.
Fitting the Splitter and Blade Guard
Mounting the Table Saw to a Bench
Dust Extraction Port
Rip Fence
Mitre Guide
3 - 5mm
