SCMS-8STAND
4. OPERATING THE SAW
Turning On and Off
1. To turn the mitre saw on,
squeeze the trigger switch
2. To turn the mitre saw off,
release the trigger switch
Laser Guide
It is extremely important to
always secure the workpiece
properly and tightly with the
material clamp.
Note:
Before performing a cut, ensure the blade is at full speed.
Failure to do this may cause the blade to become blunt and cause
the blade to lock-up.
Slide Action
When cutting wide pieces of
wood, ensure the slide lock is
loose.
1. First pull carriage fully, slide the release lever right with your
thumb and press handle down.
2. Push carriage toward the rear fence.
Place the workpiece flat on the
mitre table with one edge securely
against the rear fence.
Note:
If the workpiece is warped,
ensure the concave (curves
inward) side is against the rear
fence.
Workpiece
WARNING!:
DO NOT STARE DIRECTLY AT
THE LASER BEAM.
1. To switch the laser guide on,
press the laser guide switch to
the On (I) position.
2. To switch the laser guide off,
press the laser guide switch to
the Off (0) position.
Note:
Ensure that the laser guide is switched off when the saw is
not in use.
Material Clamp
A laser line is projected onto the material you wish to cut, providing
an exact guide for the cut.
