2. CHANGING ACCESSORIES CONT.
3. CHANGING ACCESSORIES CONT.
Locating a cutting/sanding disc
Locating a sanding drum
2 Fit the fibre flange either side
of the cutting disc, then insert
the screw.
1 Loosen the screw on the top
of the sanding drum holder.
3 Tighten the cutting disc onto
the cutting disc holder.
2 Slide the sanding drum onto
the sanding drum holder.
1 Remove the screw from
the end of the disc holder.
Note:
Do not over-tighten the screw as it could result in damage to the
cutting disc.
3 Tighten the screw until
the sanding drum sleeve
is secured.