DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed
of with household waste but in an environmentally friendly way.
Please recycle where facilities exist. Check with your local
council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
SPARE PARTS
Read instructions
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
/min
Revolutions or
reciprocation per minute
n
o
No load speed
Warning
Do not expose to rain
dB
Decibel (noise) rating
Beware of debris being
ejected from the shredder
Keep by standers away
Wear eye and ear protection
Wear safety gloves
Sound power level
Danger - Rotating blades. Keep hands and feet out
of openings while machine is running
112
Disconnect and discontinue
use should the power cord
be damaged
Double insulated
Problem
Cause
Solutions
The motor does
not run
The shredder
may have been
overloaded.
Wait 1-5 minutes and allow
the motor to cool down.
Move the on/off switch
to the ON “I” position to
restart the shredder.
The closure
between the
shredder housing
and motor housing
has not been closed
correctly.
The safety interlock
will not allow power to
the shredder. Open the
housing and ensure the
contact surfaces are
clean. Refit and tighten
the locking knob in a
clockwise direction.
Power failure.
Check the power supply/
cord and house fuse.
The material to
be shredded
is not pulling
through the unit
The hopper plate is
blocked.
Disconnect all power and
unscrew the locking knob.
Carefully clean all debris
and free organic matter
from the discharge area.
Lower the housing and
tighten the locking knob to
ensure it is secure.
The blades are blunt
and need to be
changed.
Reverse or replace the
blades.
The motor is
cutting out on
overload
The blades are blunt
and need to be
changed.
Reverse or replace the
blades.
Smoke is coming
out of the hopper
The cutter assembly
is clogged.
Open the shredder and
clean out the hopper.
TROUBLESHOOTING
Read the operating instructions.
Wear safety goggles.
Safety class II
Never expose the
device to rain
Wear ear protection
If the cable is damaged or cut, disconnect the power plug from
the mains immediately.
Maximum cutting length / chain speed vu: 13.5 m/s
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
