Starting the shredder
1. Connect the power cord to an appropriate extension cord and plug
the extension cord into the mains power point.
Note:
The device has a internal zero voltage switch. This prevents the
device restarting unintentionally after a power failure.
2. To start the shredder move the on/off switch to the
ON “I” position. When the shredder is turned on
there will be a short delay before the motor starts
and the speed will fluctuate for a few seconds.
This is normal as the shredder is fitted with a
preset speed controller designed to keep the
shredder at its optimal speed when in use.
3. To stop the shredder move the on/off switch
to the OFF “O” position.
5. Insert each wheel over the wheel bush
ensuring that the larger inner diameter
of the wheel is facing outwards. This
allows the wheel cap to be fitted.
6. Place the axle washer onto the
wheel axle followed by the axle
nut. Secure the flat of the wheel
axle with a 10mm spanner (not
included) and tighten the axle
nut using the spanner, turn in a
clockwise direction.
7. Place the wheel cap onto the
wheel and click in place.
8. Once fully assembled carefully
lift the shredder into its correct
position supported by the
stand and wheels.
2. STARTING
OPERATION
WARNING!
PRIOR TO STARTING THE MOTOR
ENSURE THE SHREDDER IS EMPTY. ENSURE
YOU WEAR SAFETY GLOVES, SAFETY GLASSES AND
EARMUFFS WHEN THE SHREDDER IS IN USE.
ON
OFF
ON
OFF
WARNING!
THE POWER SUPPLY FOR THIS
PRODUCT SHOULD BE PROTECTED BY A
RESIDUAL CURRENT DEVICE RATED AT 30mA OR LESS.
9. Attach push stick holder to stand for
easy access of your push stick.
