ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
Attaching The Mounting Bar & Cables
1. Loosen the leg fastening knob on
the stem of the tripod by turning
it anti-clockwise.
2. Push down on the tripod leg ring
while maintaining a firm grasp
on the tripod stem to extend the
tripod legs.
3. Turn the leg fastening knob clockwise to lock the tripod legs in place.
4. Slide a fastening knob into the
bracket on the cable junction
unit, then through the central
hole on the mounting bar.
Note:
The cable end with the
3-pin power plug (longest cable
length) should be pointing towards
the ground.
5. Slide a washer onto the end
of the fastening knob and then
screw this assembly into the
channel on the top of the tripod.
Installing The Worklights
1. Place a fastening knob through
the hole in the frame of a
worklight, then slide a washer
onto the fastening knob.
2. Insert the assembly through the
hole on one end of the mounting
bar and fasten from below with
one of the supplied wingnuts.
3. Repeat steps 1 & 2 with the other worklight.
1. AC Power Socket
2. Battery Seating
3. Dimming Control Knob
4. Worklight Frame
5. Rotation Adjustment Bolt
6. Frame Fastening Knob
7. Tripod Upper Section
8. Stem Fastening Knob
9. Tripod Stem
10. Leg Fastening Knob
11. Tripod Legs
12. Leg Support Bars
13. Cable Management Hook
14. AC Power Cord
15. Mounting Bar
16. LED Worklight
17. Mounting Bar Knob
This tool is compatible with all batteries & chargers from the Ozito Power X Change
range.
HYBRID TWIN LED WORKLIGHTS
& TRIPOD
BATTERY & CHARGER
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
16
17
1
13
2
6
8
10
9
5
11
12
7
3
15
14
4
