MAINTENANCE
•
Keep ventilation slots of the trimmer clean at all times. Periodically clean out the grass from the
cutting head and the rim of the blade guard to ensure efficient operation at all times.
•
After each use, blow air through the tool housing to ensure it is free from all dust, dirt, etc. Build
up of dust, dirt particles may cause the tool to overheat and shorten the life of the tool.
•
If the housing of the trimmer requires cleaning, do not use solvents but a moist soft cloth or soft
brush only.
•
Never let any liquid get inside the tool, never immerse any part of the tool into liquid.
• No lubrication is necessary as the tool has sealed bearings.
•
When not in use, the grass trimmer should be stored in a dry, frost free location not within the
reach of children.
WARNING!
ALWAYS ENSURE THE TOOL HAS
COMPLETELY STOPPED AND THE BATTERY IS
REMOVED PRIOR TO ANY MAINTENANCE.
Note: Ozito Industries will not be responsible for any damage or injuries caused by the repair of
the grass trimmer by an unauthorised person or by mishandling of the grass trimmer. This tool is
designed for DIY use - use in commercial or industrial environments will void the warranty.
5. TRIMMING & EDGING
OPERATION
Trimming
Edging
Move the grass trimmer from side to side as
you walk forward, holding it at an angle of
approx. 30° (Light cuts are better than heavy
cuts as they allow the cut grass to fall away
from the cutting head).
Place the edging guide along the ground
and slide the grass trimmer along the edge
of the path.
Battery protection system
The tool is equipped with the battery protection system, which helps to ensure a long service
life.
The output power automatically cuts off during operation when the tool and/or battery are
placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of overload, then pull the
switch trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during use or immediately
after using the tool.
30°
