1 Align the holes in the upper
handle and lower handle.
Care should be taken not
to impinge cord.
3 Place a washer and the
handle securing lever onto
the bolt to secure in place.
1 Lift up the grass catcher
flap while guiding the
catcher into the 2 hooks.
3 To remove, raise the flap
and lift the catcher out.
2 Place the handle securing
lever bolt through the holes
from the inside.
4 Repeat this process for the
opposite side.
2 Once the grass catcher is
in place, the flap can be
lowered.
Fitting the Upper Handle
Fitting and Removing the Grass Catcher
WARNING!
WHEN FITTING THE GRASS CATCHER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD UP OF
GRASS IN THE GRASS CHUTE.
IMPORTANT!
ONLY FIT AND REMOVE THE CATCHER
WHEN THE MOWER IS SWITCHED OFF AND THE MOTOR
HAS COME TO A STOP.
1 Release both quick
adjustment levers and
rotate the handle into the
desired position.
2 Secure in place by
tightening both quick
adjustment levers.
1 Locate cord on outside of
handle. Push the supplied
cord clips over the cord
and onto the handle to
secure in place.
If the indicator flap is down
while operating then the grass
catcher is full and needs
emptying.
Note
:
Care should be taken not to impinge cord when folding
down the handle.
Adjusting the Handle
Securing the Cord
Grass Catcher Indicator
Ensure the cord follows the handle smoothly from the switch to
the body of the mower.
The grass catcher is fitted with an
indicator flap at the rear of the catcher
to help identify when to empty.
1 Clip the two lower side
halves together by pushing
each lug firmly until it clicks
in.
2 Align the upper part and
the lower halves and push
each individual lug into its
opposite location.
Assembling the Grass Catcher
