MAINTENANCE
DESCRIPTION OF SYMBOLS
Wear hearing protection
Wear eye, ear & breathing protection
Wear gloves
Wear breathing protection
Wear eye protection
Warning
Regulatory Compliance Mark
(RCM)
Double insulated
V
Volts
mm
MIllimetres
n
0
/min
Direct Current
No load speed
Revolutions per minute
Read Instruction Manual
Power tools that are no longer usable should not be disposed
of with household waste but in an environmentally friendly
way. Please recycle where facilities exist. Check with your local
council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in the
environment. Please recycle packaging where facilities exist.
Check with your local council authority for recycling advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders
Desk at your local Bunnings Warehouse.
For further information, or any parts not listed here,
visit www.ozito.com.au or contact Ozito Customer
Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
WARNING!
BEFORE CLEANING OR CARRYING OUT
ANY MAINTENANCE PROCEDURE, ENSURE THAT
THE BATTERIES HAVE BEEN REMOVED.
Cleaning
• Keep the ventilation slots of the tool clean at all times to ensure efficient
operation.
• After each use, blow air through the tool housing to ensure it is free from
all dust, dirt, etc. Build up of dust or dirt particles may cause the tool to
overheat and shorten the life of the tool.
• If the housing of the tool requires cleaning, do not use solvents. Use of a
cloth only is recommended.
• Never allow any liquid to get inside the tool, never immerse any part of
the tool into liquid.
Cleaning The Dust Guard & Ventilation Mesh
1. Gently flex one side of the dust
guard away from the handle.
2. Unhook the dust guard from
the tool.
3. Use compressed air to clean the ventilation mesh on the tool and dust
guard. If necessary, use a soft, dry cloth to wipe the dust guard clean.
4. Press the pins on the inside of the dust guard against the tool handle and
then re-attach the dust guard.
Storage
When not in use, the tool should be stored in a dry, frost free location, keep
out of children’s reach.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by repair of the tool by an unauthorised person or by
mishandling.
